Start

Documentation

Learn the simulator by using it.

Guides run the real tiles on the page, every number comes from the same solver as the app, and your AI assistant can read all of it.

Look up a tile

Every tile on your dashboard has a page: what it shows, how to read it, and what to change when it looks wrong.

All 27 tiles
SPL (dB)Level against frequencyF3 30 HzMax SPL (dB)The loudest it gets before a limit121 dB at 32 HzExcursionCone travel against Xmaxpeak 15.0 mm · Xmax 13.5 mmPort VelocityAir speed against the 17 m/s linepeak 20.1 m/s at 30 HzImpedanceThe tuning shows as peaks and a dippeaks at 19 and 50 HzAmplifier Load (VA)What the amplifier has to deliverpeak 113 VA at 191 Hz
21 more tilesReference: controls, T/S parameters and the glossary

The vented example (Ciare 12.00SW in 55 L, tuned to 32 Hz) at 100 W, half space, 1 m. Simulated when this page was built. Open this example

Start here

Three ways in: build a design, compare the enclosure types, or hand the work to your assistant.

Walkthrough · live tilesYour first designBuild the vented example and watch its SPL, excursion and port velocity in the real tiles as the power goes up.Start the walkthroughBoxes and hornsChoose an enclosure typeWhat each enclosure type trades for its bass, shown on the app's own example designs.Compare the typesClaude · ChatGPT · Claude CodeConnect your AI assistantYour assistant runs the same solver on your own workspaces, through 39 tools.Connect an assistant

Also in Start

Speaker design basics

Worked examples

Find it by task

All guides

Drivers

Boxes

Horns

Power and limits

EQ and comparing

Work in the app

Measure and verify

Share and build

AI and MCP

Your assistant can read these docs.

Connect Claude, ChatGPT or Claude Code once. It builds and checks designs in your own workspaces with the app's solver, through 39 tools, and search_docs and read_doc let it find and quote the page that explains what it found.

  • Ask AI on any docs page writes the prompt for you, with that page attached.
  • Copy the prompt, or open it straight in Claude or ChatGPT.
  • It shows whether your assistant is connected, and how to connect it if not.
  • Every docs page also comes as Markdown (add .md to its address), and llms.txt lists them all, for any other tool.
Connect an assistantThe 39 tools
Your assistant00 SIMULATOR CONNECTED

Why does the port on my 12-inch sub go over the line at 200 W?

  1. get_workspaceVented · Ciare 12.00SW · 55 L · 200 W
  2. simulate_workspaceas saved
  3. simulate_workspaceoverrides · numPorts 2, not saved
  4. render_simulation_graphsportVelocity
  5. read_doc/docs/reference/tiles/port-velocity

At 200 W your 10 cm port peaks at 28.4 m/s near 30 Hz, over the 17 m/s line. Two 10 cm ports bring it down to 14.2 m/s, but each has to be 77 cm long to keep the 32 Hz tuning (the single port is 36 cm). Port Velocity

An example conversation. The tools are the connector's own; the numbers are the solver's. The vented example at 200 W, with one and with two 10 cm ports, simulated when this page was built.